PSoC™ 4 Forum Discussions
Hello.
Customer would like to confirm reset trigger.
They would like to distinguish which reset occurred.
Is there way to confirm which reset trigger of Power On Reset, Brown out Reset and External Reset occurred?
If PSoC4(CY8C4125) has it, could you please let us know a detail of specific method for confirming such reset triggers?
And does PSoC4(CY8C4125) have BOR function?
Or does not PSoC4 have BOR, does PSoC4 have only BOD(detect only, do no reset)?
Best Regards.
Yutaka Matsubara
Show LessWondering if there is a bare bones example in C# code using the CySmart API to setup and talk to the dongle ??
The reference guide does not provide one, and its not clear to me at least how to properly start things up, etc..
Show LessI need to know the version of the program that was previously designed with CY8C4127LTI-M475.
However, I don't know how to read program data for PIC.
Please let me know if you have any reading methods or tools.
Show LessI need to send some data to a PSOC device via Cypress BLE dongle (CY SAMRT 4.2)
This through a dedicated GUI I am building.
I am looking for a library I can use to access the dongle via the USB port.
Any documentation on that?
Show LessUsing Windows 10
Using the USB Audio example on the mentioned cy8ckit-046.
The device enumerates but does not stream audio out the audio jack.
No changes to the example were made.
Keith
Show LessDatasheets for PSoC 4000 CY8C4013SXI-410 and PSoC 4200 CY8C4245AXI-483, do not list DC current consumption for programming/erasing/writing FLASH.
For VDD of +5V, 16MHz for 4000 and 48MHz for 4200, 25C temperature, what are the FLASH programming DC current spec's for these devices?
PSoC 5LP lists this parameter in its datasheet as Idd_prog.
regards,
Bill
Show LessHi,
I am developing a project for the PSoC 4 board.
I have exported the project to keil in order to see the variables in real time.
Who is the best programmer to debug the project?
Thanks
Show LessHi,
I just bought a CYBLE-212020-01 which I am planning to put on a custom PCB and I would like some help to get started. I started to read through the documentation that prompted some early question.
Is there an eagle library so that I can start designing the PCB?
Once the PCB is designed, can I use a regular FTDI USB to TTL Serial Adapter instead of buying an eval kit?
If yes, do I need to hook TX/RX only or I need CTS/RTS as well?
Once hooked up, what software I need to use to be able to program the chip?
Thank you
Show Less