- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can't seem to seem to find a value showing what the noise current in the IDAC output is? Where can I find this value? Are there any known techniques to reduce the noise output?
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Are you facing any particular issue in your design ? Regarding IDAC output accuracy, you can check the CSD block parameters in the device datasheet. The IDACs are mainly used for the capsense block - so the parameters are listed there. The INL and DNL of the IDACs can be seen there.
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Are you facing any particular issue in your design ? Regarding IDAC output accuracy, you can check the CSD block parameters in the device datasheet. The IDACs are mainly used for the capsense block - so the parameters are listed there. The INL and DNL of the IDACs can be seen there.
Best Regards,
Vasanth