Oct 22, 2015
10:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 22, 2015
10:49 AM
Hello.
I am trying to develop an application in which the processor is awaken from deep-sleep mode via an external GPIO interrupt, I am facing some problems with the same.
I believe since nested vector interrupts are enabled, the program control jumps from the Cy_Bless_ISR and the ADXL_ISR. Is there any way in which the system can go to main after the external interrupt ISR has been serviced.
Labels
- Labels:
-
BLE
1 Reply
Anonymous
Not applicable
Nov 04, 2015
06:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 04, 2015
06:37 AM
Hi,
For the Firmware to start from the main upon wakeup from GPIO Interrupt, can you consider using hibernate instead? It will give you even less power consumption.
Regards,
- Madhu Sudhan