- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I started a new BLUETOOTH project and so I choose the Cypress solution. Last month I started doing some experiments with "CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit". Good examples. Now I would like to program my board using the kit programming pins (see j11 connector). The microcontroller on the board is the cy8c4127lqi-bl473. Unfortunately the psoc-creator and the psoc-programmer not recognize il chip. What should I watch inside the board ? Best regard. Alberto
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi BMAH,
I have found the problem... for routing problems the SDAT-pin was reversed with the SCLK-pin ... so now it works.
Best regards
Alberto
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Alberto,
From the problem description, it seems like the device cannot be acquired in Programmer. Can you share the schematic of your board? Did you connect any external voltage to the VCCD Pin? If so, please remove it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi BMAH,
I have found the problem... for routing problems the SDAT-pin was reversed with the SCLK-pin ... so now it works.
Best regards
Alberto