cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Hello, I"m very new to PSoC.

I want to let existing program which I got from another person to work.

The program have been built perfectly. So if I set my PSoC creator correctly, it can work.

However there is a note and a warning.

The note is "pft.M0040: The following 2 pins will be assigned a location by the filter:\USBFS_1:Dm(0)\,/USBFS_1:Dp(0)\"

The warning is "sta.M0021:Warning-1350: Asynchronous path(s) exist from "\ADC_DelSig_1:DEC\ /interrupt" to "CyBUS_CLK". See the timingreport for details.

When I try to program and debug, it collapsed by encountering error.

I'm afraid that the warning causes this error.

I know that ClockSyncronization is problem and I should add some clock components to my program.

Please teach me how to put clock component.

or should I have to change any settings?

I attached my time report also.

And I write configuration of my PC

Windows10

PCoS Creator 4.2

My board is PSoC 5lp (CY8C5)

Thanks in advance

0 Likes
1 Solution
Vasanth
Moderator
Moderator

Hi,

The error comes because of timing differences of clocking network. You can use a sync component to solve it.
Please check the following document : http://www.cypress.com/file/179056/download, page 20.

Best Regards,

VRS

View solution in original post

0 Likes
5 Replies
JoMe_264151
Expert II

Can you please post your complete project or a shortened version that shows the error so that we all can have a look at all of your settings. To do so, use

Creator->File->Create Workspace Bundle (minimal)

and attach the resulting file.

Bob

0 Likes
Anonymous
Not applicable

Hi, Bob.

Thanks for your replying.

I'm sorry to be late.

Now I retry to build and debug.

It seems to disappear these warning and note.

I don't know the reason why.

However, when I try to debug, it remained same encountering error.

I attached zip file of my code.

Regards.

Misato

0 Likes
Anonymous
Not applicable

I'm sorry...

After it took few minutes.

Above warning and note appear again...

I cannot solve the problem basically.

Misato

0 Likes
Vasanth
Moderator
Moderator

Hi,

The error comes because of timing differences of clocking network. You can use a sync component to solve it.
Please check the following document : http://www.cypress.com/file/179056/download, page 20.

Best Regards,

VRS

View solution in original post

0 Likes
Anonymous
Not applicable

Thanks!!

I could understand how to connect Sync components.

And I could solve the problem.

Regards

Misato

0 Likes