cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

After checking

   

 Figure 20. CYBLE-022001-EVAL Board Pinout in Spec 

   

and PRoC BLE in PSoC Creator 3.2

   


There is a bug in Spec and the board

   

 

   

In CYBLE-022001-EVAL Board Pinout,
the pin P1_3 should change to P4_0 with red color
and then publish a new board for it

becuase EZ-Module P4_0 need to connect to this pin.

I think it is a layout bug   

0 Likes
Reply
3 Replies
Anonymous
Not applicable

 Hi,

   

 

   

We don't get your point .I checked it again and I don't any difference.

   

 

   

In creator there is no eval board option. There is only CYBLE-022001-00.

   

 

   

Please give exact pionters of the error that you found out.

   

 

   

Regards,

   

Vikas

0 Likes
Reply
Anonymous
Not applicable

Hi VAVC:

   

(1)

   

See the attched file 

   

http://www.cypress.com/?docID=54133

   

The picture is from Cypress specification 

   

Look the left -side in this picture and you will see that  P1_3 

   

Actually there is no P1_3 in EZ-Module

   

 

   

 

   

(2)

   

By the way, EZ-Module has P4_0  (Open PSoC Creator and you will see it)

   

But there is no P4_0 on the green EVAL board.

0 Likes
Reply
Anonymous
Not applicable

1) There is no pin 1_3 on the CYBLE-022001-EVAL board/chip. It sounds like you are suggesting redoing the layout to have pin 4_0 replace the pin 1_3 on the pioneer board only?

2) The EVAL board is mainly for evaluation purposes I would suspect, and thus you only need to verify that the chip will do what you want? Why do you need access to the pin 4_0 specifically? Any of the other pins already broken out should be good enough to demonstrate functionality for the chip.

0 Likes
Reply