Report hardware bug for PRoC BLE 600-20077-01_REV1_0 EVAL baseboard

[Anonymous]

After checking

   

 Figure 20. CYBLE-022001-EVAL Board Pinout in Spec 

   

and PRoC BLE in PSoC Creator 3.2

   

There is a bug in Spec and the board

       

In CYBLE-022001-EVAL Board Pinout,
the pin P1_3 should change to P4_0 with red color
and then publish a new board for it

becuase EZ-Module P4_0 need to connect to this pin.

I think it is a layout bug   

[Anonymous]

 Hi,

       

We don't get your point .I checked it again and I don't any difference.

       

In creator there is no eval board option. There is only CYBLE-022001-00.

       

Please give exact pionters of the error that you found out.

       

Regards,

   

Vikas

[Anonymous]

Hi VAVC:

   

(1)

   

See the attched file 

   

http://www.cypress.com/?docID=54133

   

The picture is from Cypress specification 

   

Look the left -side in this picture and you will see that  P1_3 

   

Actually there is no P1_3 in EZ-Module

           

(2)

   

By the way, EZ-Module has P4_0  (Open PSoC Creator and you will see it)

   

But there is no P4_0 on the green EVAL board.

[Anonymous]

1) There is no pin 1_3 on the CYBLE-022001-EVAL board/chip. It sounds like you are suggesting redoing the layout to have pin 4_0 replace the pin 1_3 on the pioneer board only?

2) The EVAL board is mainly for evaluation purposes I would suspect, and thus you only need to verify that the chip will do what you want? Why do you need access to the pin 4_0 specifically? Any of the other pins already broken out should be good enough to demonstrate functionality for the chip.