cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Hey guys, I've connected rc522 module to psoc4 using i2c, but I dont know how to correctly test it, how o get some info from card or key. If it possible, to control it in Bridge control or in Putty?

0 Likes
Reply
4 Replies
Esteemed Contributor II

Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.

   

Additional question: Which Cypress Kit do you use for that project?

   

 

   

Bob

0 Likes
Reply
Anonymous
Not applicable

I'm using pioneer kit cy8ckit042. Here is zip archive  of my project.

   

It is little bit change if to compare with question, I changed from i2c to UART. RFID module I used- rc522 
http://www.nxp.com/documents/data_sheet/MFRC522.pdf
With such pinout - http://rootger.blogspot.com/2014/07/rfid-rc522-pinout.html
In project is no special firmware, because I don't know how to test it correctly.

0 Likes
Reply
Anonymous
Not applicable

Sorry for bothering you, could you help me with my problem?

0 Likes
Reply
Anonymous
Not applicable

I don't understand table 5 of http://www.nxp.com/documents/data_sheet/MFRC522.pdf 

   

1) The headers UART (input) $  SPI (output) $ I 2C-bus (I/O) 

   

    My understanding is that in all three modes, the MFRC522 acts as subaltern=slave, and as it is a dialog and not a monolog, pins can be input or output.   So why is UART declared as input only and SPI as outout?

   

2) I2C  does it mean, that to use/enable I2C-mode, pin 1 has to be hardcoded as "1", so connected to +Vcc?

   

3) Should the table not be enhanced with an additional column on the right so that one column explains use of pins if EA=1 and the other when EA=0?

0 Likes
Reply