cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

New Contributor

Hello,

I followed the guide to putty to use it as terminal for displaying debug output. The output from the commands appear not correctly in

putty. I checked all settings of the terminal over and over again but i am not able to fix this situation.

I am thankful for all hints to solve the apperance issue.

Thank you,

Daniel

0 Likes
Reply
3 Replies
Moderator
Moderator

Hi Daniel,

Do you mean the receive command is not correct, instead of no command?

First of all, check if the hardware has been connected correctly.

Secondly, check if you choose the correct serial port.

Thanks,

Lingling

0 Likes
Reply
New Contributor

Dear Lingling,

thank you for your quick response.

The port is correct, i assume that from the timings when the unreadable output appear in putty.

The cable is the original which came with the kit. Also reboots are not helpful.

Thank you very much,

Daniel

0 Likes
Reply
Moderator
Moderator

If HW connection and setting are correct, the next is check the firmware running in the 4200 chip is free of problem, some other discussion about using Putty in this community:

Using UART to send characters to putty

Two PSoC 4 serial communication using putty

How do I get the result of the ADC printed on Putty? I am using PSoC 5LP developmental board with P...

Roy Liu
0 Likes
Reply