- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can not seem to get Creator to program a CY8C4247AZI using a MINIPROG3. I am using the ISSP 5 pin connection on the MINIPROG. What aim i doing wrong ... do i need to use a different setup to code this part? I would sure appreciate some help in getting my CPU programmed in circuit.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
While using Internally regulated mode, external power must not be applied to the Vccd or Vcca pins. THIS MAY DAMAGE YOUR DEVICE.
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A bit more information could help.
Miniprog visible in debug target selection?
From where is your pcb powered?
selected programming mode (power cycle or reset)
Did you try PSoC programmer?
Any error messages?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob ... thank for trying to help me i am new to PSoC
1. I don't know if its visible .. don't quite know were to look as of yet. I will do so now!
2. Power is from my external power 3.3 volt power supply.
3. As far as PSoC programmer i could never get to my particular device. It doses not show up on any of the lists.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is screen shot of what i am getting... Scott
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Creator -> Debug -> Select Debug target. Miniprog connected to USB should show up.
PSoC Programmer: Latest version is 3.26. Check for updates. Can be that the miniprog needs update, PSoC programmer will tell you.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. Yes Miniprog3 does show up in Debug target
2. I am running version 3.26 of programmer
3. How do I update Miniprog3?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Programmer is up to date and so is Miniprog ... still no luck
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your screenshot (which I didn't see until now) lets me assume that you are not running Creator 4.1.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob,
I updated to Creator 4.1 but still can not program with MP3 in either Creator or with PSoC Programmer.
Very frustrated!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
While using Internally regulated mode, external power must not be applied to the Vccd or Vcca pins. THIS MAY DAMAGE YOUR DEVICE.
Best Regards,
VSRS