Jul 26, 2017
01:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 26, 2017
01:47 PM
Is it possible to program external PSoC-4M chip using the kitprog on cy8ckit-043?
I have broken apart the kitprog portion of the cy8ckit-043 and have connected its SWD pins to external psoc-4m device. But it's not working.
Is it possible to program external chips using this method?
Thanks
Solved! Go to Solution.
Labels
- Labels:
-
ispn:39613:1:0
-
l1:314:1:0
1 Solution
Jul 27, 2017
01:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2017
01:06 AM
Yes, programming will work. You need a 5V design and you need to connect all 5 pins (VDD, GND, XRES, SWDCLK and SWDIO).
No external powering of the board.
Bob
2 Replies
Jul 27, 2017
01:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2017
01:06 AM
Yes, programming will work. You need a 5V design and you need to connect all 5 pins (VDD, GND, XRES, SWDCLK and SWDIO).
No external powering of the board.
Bob
Aug 09, 2017
01:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 09, 2017
01:37 AM
Thanks for the reply. Works absolutely fine. The RESET pin was accidentally grounded so it didn't work in the first shot.