Hello, I have been using the PSoC 4 M-Series Pioneer Kit for a while without any problems. Now I'm having trouble connecting to the board. When I try to enter Debug mode it gives me an error saying the "Port Acquire Failed". I have rebooted my laptop several times and have tried different USB ports. When I plug the board into the USB port it does power on and runs the last program I executed.
Has anyone had this trouble or may have some suggestions on how to connect to the board, if so please let me know.
Thanks,
Joe
Here is the screen shot of the error message.
Try pressing the reset button for more than 10 seconds to change the kitprog's mode. See kitprog manual.
Happy 2017!
Bob
Bob,
HI and Happy New Year to you too. I found my problem. It was a driver problem. I reinstalled the drivers and everything is okay.
Thanks,
Joe
Hi,
Could you please create a new thread ?
Best Regards,
VSRS
Hello! I have the same problem now.Could you please tell me where you get the drivers?
The drivers come with PSoC Creator I believe, so it would be in the install files with it?
Thanks, I will try to install this once again.