cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

New Contributor II

Trying to communicate with a PSoC4200BLE of the type CY8C4248LQI-BL593.

Mounted it on a breakout board and trying to program it for the first time through a CY8CKIT/146 P|SoC 4200DS prototyping kit, by using PSoC Programmer and Creator

We have tried by HSSP but we had problems, are there other ways to communicate with the PSoc4BLE?

Any suggestions about how to proceed?

Any specific documentation, step by step guide or similar problem?

0 Likes
Reply
1 Solution
Moderator
Moderator

KitProg2 (CY8C5868LTI-LP039) is the onboard programmer/debugger and supports only Cypress-developed Kits. It will not work (may, but no guarantee) with any custom hardware or with Cypress Kits customized for different MPN. You can use any of the following three programming methods:

We have PSoC 4 HSSP code example project available here. Please use the PSoC Creator project and follow the code example document. Since CY8CKIT-146 4200DS has KitProg2, please refer section: 'For Kits with Onboard PSoC 5LP Programmer (KitProg2)'.

View solution in original post

0 Likes
Reply
1 Reply
Moderator
Moderator

KitProg2 (CY8C5868LTI-LP039) is the onboard programmer/debugger and supports only Cypress-developed Kits. It will not work (may, but no guarantee) with any custom hardware or with Cypress Kits customized for different MPN. You can use any of the following three programming methods:

We have PSoC 4 HSSP code example project available here. Please use the PSoC Creator project and follow the code example document. Since CY8CKIT-146 4200DS has KitProg2, please refer section: 'For Kits with Onboard PSoC 5LP Programmer (KitProg2)'.

View solution in original post

0 Likes
Reply