PSoC4100SP:PROTECTED mode verify

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
RyYo_1406951
Level 5
Level 5
100 replies posted 50 replies posted 25 replies posted

Please answer below.
The same question is written in English and Japanese.

・English
Device Security is set to "PROTECTED mode".

I am thinking as follows. Are you sure?
"PROTECTED mode" does not run "Verify" of "PSoC Programmer".

・Japanese(日本語)
Device Securityを"PROTECTED mode"に設定しております。

以下の様に考えております。間違いないでしょうか?
"PROTECTED mode"では、PSoC ProgrammerのVerifyはできない。

Regards

0 Likes
1 Solution
SanjeevG_16
Employee
Employee
10 likes received 10 likes given 5 likes given

Hi,

During the verify operation, the PSoC Programmer reads the flash blocks from the target device and compares it with the hex file you have specified. Because the device security is in PROTECTED mode, the PSoC Programmer cannot read the flash. So, it will throw an error. You can try Verify Checksum operation which verifies the checksum of the target device with the hex file.

Thanks.

View solution in original post

2 Replies
SanjeevG_16
Employee
Employee
10 likes received 10 likes given 5 likes given

Hi,

During the verify operation, the PSoC Programmer reads the flash blocks from the target device and compares it with the hex file you have specified. Because the device security is in PROTECTED mode, the PSoC Programmer cannot read the flash. So, it will throw an error. You can try Verify Checksum operation which verifies the checksum of the target device with the hex file.

Thanks.

0 Likes