- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Below, the same sentences are written in English and Japanese.
・English
AN 88619 PSoC 4 Hardware Design Considerations states "large sink current".
What is the specific mA for "large sink current"?
・日本語(Japanese)
AN88619 PSoC 4 Hardware Design Considerations に「large sink current」と記載あります。
「large sink current」は具体的に何mAでしょうか?
Regard
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
The maximum current is defined for a port to which the CapSense is connected.
The total port current should not exceed 40 mA while the CapSense block is scanning the sensor. Please refer to CapSense Design guide, sensor and device placement section for more details.
Link : https://www.cypress.com/file/46081/download
It is also not recommended to route any high speed switching lines close to the CapSense sensor pins or traces due to introduction of crosstalk which might lead to inaccurate results.
Do let us know in case of any further clarification.
Thanks and regards
Harigovind
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
The maximum current is defined for a port to which the CapSense is connected.
The total port current should not exceed 40 mA while the CapSense block is scanning the sensor. Please refer to CapSense Design guide, sensor and device placement section for more details.
Link : https://www.cypress.com/file/46081/download
It is also not recommended to route any high speed switching lines close to the CapSense sensor pins or traces due to introduction of crosstalk which might lead to inaccurate results.
Do let us know in case of any further clarification.
Thanks and regards
Harigovind
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Harigovind-san
Thank you for your answer.
Regards