- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm using the PSoC programmer on some custom boards with CY8C5868LTI-LP038.
I can program properly most of them.
However, for 2 of them I always get this error message:
"262144 FLASH bytes
Erase Succeeded
Programing of flash starting
Failled: Time out of SPC Polling
Lost communication with chip
Status=0x82"
For the other one the message ends with "Status=0x26".
I've inspected the 5 wire connection from the programmer to the board and every thing seems OK.
I was wondering if anyone could give me a hint of what these error codes mean, so I know what to look for.
Any feedback is appreciated.
Thank you.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you share the schematic of your board so that I can have a look? But since other boards are getting programmed correctly, I don't think the schematic has any problems. The two boards might be faulty which could be the only reasoning I can think of.
Regards,
Dheeraj