- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am planning to use PSoC 4000S - CY8C4025AZI-S413 in deep sleep mode.
And controller should wake - up on CapSense button press.
Is it possible to wake-up from deep sleep on capsense button press?
If anyone having related reference, please do share. It would be the great help for me..
Thanks in advance.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A new PSoC Creator project sets the debug interface pins to SWD mode by default. Use the System tab in the .cydwr file of the PSoC Creator project to set the pins to GPIO mode, as Figure shows.
Program the kit to reflect the changes. Measure and let me know what current consumption you see
For more information please refer: https://www.cypress.com/file/121271/download
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi...
Thanks for the reply...
I tried with deep sleep mode...Ideally the current consumption in deep sleep mode should be in uA....but I found the current in mA i.e 1.09mA
code will be like this:
int main(void)
{
CyGlobalIntEnable;
for(;;)
{
CySysPmDeepSleep();
}
}
No any peripheral configure yet.....sch. page is empty.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A new PSoC Creator project sets the debug interface pins to SWD mode by default. Use the System tab in the .cydwr file of the PSoC Creator project to set the pins to GPIO mode, as Figure shows.
Program the kit to reflect the changes. Measure and let me know what current consumption you see
For more information please refer: https://www.cypress.com/file/121271/download
Regards,
Dheeraj