Hi,
This is a very interesting project. I am about to work on something similar, a project that will read stereo audio, buffer it, and send it back out again as a delay. Great project, and a good start for me! What are you using for an antenna?
Thank you,
Tom
In this project the antenna was just a 60 cm piece of wire, but it isn’t calibrated with de 1/4 of the wave length, because that would be to long, and because my knowledge on antennas design is low, so I don’t know how to design the analog network to compensate for the sort wire antenna. But for my case it worked.
Best regards,
João Nuno Carvalho
What is the part number of the open drain transistor? could you show a better schematic of the output and the antenna.
Thanks
There is no part number for the open drain transistor, it’s the PSoC 4 pin that is configured to function like that.
All the parts of the project are in the PSoC Creator schematic.
Thank you,
Best regards,
João Nuno Carvalho