cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

1/ I am using the Using the CY8CKIT-042 BLE board, with the CYBLE 212019-00 microcontroller.

   

2/ I’ve created a workspace with :-

   

The following 2 projects :-

   

BleFindme01, BLE_OTA_upgradeableStckExample_Launcher01and  BLE_OTA_upgradeableStckExample_Stack01.

   

 

   

3/ When I build the project using  PSoc Creator 3.3 ( with service pack 2)  on a laptop using windows 10, there is no problem. I can upgrade over the air with CySmart 1.2 etc.

   

4/ When I copy the workspace to my PC ( windows 7) & use PSCoc Creator 4.0, the software does advertise & when I connect the Green LED goes off, correctly.

   

5/ With the Green LED on, I press  SW2, which turn the RED LED on. However, my mobile phone APP sees the over the air update ‘message’,  but CyCSmart does not.

   

I then press the reset button, the blue led flashes momentarily, the red led comes on .

   

My mobile phone again sees the update message, but CY Smart does not..

   

The only way that I can get the microcontroller to advertise ( green LED on) is to reprogram the device through Psoc.

   

 

   

6/ The version of CYSmart is 1.2.0.122 on both PSs.

   

 

   

7/ Where is the problem ?

0 Likes
Reply
1 Reply
Esteemed Contributor II

I would suggest you to get in contact with Cypress directly: At top of this page select "Design support -> Create a Support Case" and ask your question. You will be helped by a Cypress engineer.

   


Bob

0 Likes
Reply