- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi,
we re trying to work with a pcb that have a size of diameter 20mm.
what's the impact on range if we use a small gnd plane under the antenna ? do you have reference design for PROC+antenna used on small pcb size ?
thanks
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
See the antenna design ap nopte below -
http://www.cypress.com/?id=5509 100 Projects in 100 Days with Bluetooth
http://www.cypress.com/?rID=102799&source=psoc4ble FAQs
http://www.cypress.com/?rID=102512 AN91445 - Antenna Design Guide
http://www.cypress.com/?rID=102505 AN94020 - Getting Started with PRoC™ BLE
http://www.cypress.com/?rID=110007 AN92584 - Designing for Low Power and Estimating Battery Life for BLE Applications
http://www.cypress.com/?rID=109900 AN91162 - Creating a BLE Custom Profile
http://www.cypress.com/?rID=110107 AN91184 - PSoC 4 BLE - Designing BLE Applications
http://www.cypress.com/?rID=102504 AN91267 - Getting Started with PSoC® 4 BLE
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you already have a look at the PRoC module ? It could save you from everything except soldering.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Size would fit -