cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

RyYo_1406951
Contributor II

Please answer below.
The same question is written in English and Japanese.

・English
This connector is used by connecting the XRES terminal on the MinProg3 to the XRES terminal on the PSoC4100SP.
The XRES terminal on the PSoC 4100SP is for input only, but is the XRES terminal on the Miniprog3 for output only (Not bi-directional, no reset input)?

・Japanese
MinProg3のXRES端子とPSoC4100SPのXRES端子を接続し使用しております。
PSoC4100SPのXRES端子は入力専用端子ですが、
Miniprog3のXRES端子は出力専用端子(双方向ではない、リセット入力機能をもたない)でしょうか?

Regards

0 Likes
1 Solution
TakashiM_61
Moderator
Moderator

XRES pin on MiniProg3 is output. not bidirectional.

thanks.

View solution in original post

3 Replies
SanjeevG_16
Employee

Hi,

The XRES terminal of MiniProg 3 is used to reset the device it connects to (PSoC 4100SP).

There is no reset available either in MiniProg 3 or MiniProg 4. In case you want a reset of MiniProg for some reason, you can do a power cycle.

Thanks.

TakashiM_61
Moderator
Moderator

XRES pin on MiniProg3 is output. not bidirectional.

thanks.

View solution in original post

RyYo_1406951
Contributor II

Thank you for your support

0 Likes