May 12, 2017
12:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 12, 2017
12:39 AM
We have two MiniProg 3 (ver B) programmers that we have successfully been using for a while to program devices using power cycle mode.
Both of these no longer work. They still program other devices such as PSoC 1 successfully.
This is using the same connector harness and device which worked before, and the only change I can recall making is upgrading PSoC Programmer from some earlier version to 3.25.0.2504. I may have upgraded firmware after being prompted but cant recall for sure.
Is there some issue with 3.25 with power cycle programming on PSoC BLE devices? Specific device is CYBL10161-56.
Labels
- Labels:
-
BLE
4 Replies