- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
i need to interface 4 digit 7 segment display , 7 LED , 3 cap sense, I2C communi, two timer.
option 1
28 I/O , timer -2 nos , I2C-1 nos.
option 2
option 1 with 3 cap sense buttons.
kindly share the part number available with less cost. frequency 12MHz also fine. i need to reduce the cost. so kindly help me to get the correct controller with less cost for the option 1 and option 2.
Regards
Rajakumar.R
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello RARA_2227736
According to the specification provided, CY8C4024LQI-S413https://www.cypress.com/search/psg/1297 would be suitable. It has 34 GPIO (anmy GPIO can be configured as CapSense), 2 SCB blocks (For I2C) and 5 TCPWM for timers.
You can also refer Product selector Guide for choosing the right part for you application.
Thanks and regards
Harigovind
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello RARA_2227736
According to the specification provided, CY8C4024LQI-S413https://www.cypress.com/search/psg/1297 would be suitable. It has 34 GPIO (anmy GPIO can be configured as CapSense), 2 SCB blocks (For I2C) and 5 TCPWM for timers.
You can also refer Product selector Guide for choosing the right part for you application.
Thanks and regards
Harigovind
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello AH_96,
Thanks for your selection.
This chip absolute max gpio current is 200ma. I am going to use 10 LED (7 seg + 3 LED ). Each LED 10 mA drive current. And Each GPIO current is 25 mA max . is it Ok to operate LED direct drive without any buffer or I need to use buffer.
Thank you
Regards,
Rajakumar.R
Research and Development
Preethi Kitchen Appliances Pvt Ltd
Futura Tech Park, Q4, 4th Floor, Block B
#334, OMR, Sholinganallur, Chennai - 600 119
Mobile phone: +91-9500082969
E-mail: <mailto:Rajakumar.r@preethi.in> Rajakumar.r@preethi.in
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello AH_96,
Thanks for your selection.
This chip absolute max gpio current is 200ma. I am going to use 10 LED (7 seg + 3 LED ). Each LED 10 mA drive current. And Each GPIO current is 25 mA max . is it Ok to operate LED direct drive without any buffer or I need to use buffer.
Thank you
Regards,
Rajakumar.R
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello RARA_2227736
Since the GPIO is rated for a maximum of 25mA, it is safe to operate the LEDs on the GPIO. However, the voltage level will be maintained at VDDD-0.6 V when the current is 4mA. Hence the circuit must make sure that the output voltage is sufficient to turn ON the LED with required brightness.
Thanks and regards
Hari