Anonymous
Not applicable
Oct 22, 2018
07:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 22, 2018
07:43 PM
Hello
There is design guidline below in CapSense Design guid.
Hatched pattern 0.17 mm (7 mil) trace and 1.143 mm (45 mil) grid (25% filling) |
If we will change the layout to below, what is wrong?
Hached pattern:
- 0.01mm trace
- 0.1mm grid (10% filled)
Best regards,
Hatched pattern 0.17 mm (7 mil) trace and 1.143 mm (45 mil) grid (25% filling) |
Solved! Go to Solution.
1 Solution
Oct 23, 2018
01:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 23, 2018
01:07 AM
Modifying the fill ratio of the grid does not directly cause errors, but the parameters provided in the design manual are empirical values that have been validated for a long time. If no special reason, it is not recommended to modify it.
2 Replies
Oct 23, 2018
01:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 23, 2018
01:07 AM
Modifying the fill ratio of the grid does not directly cause errors, but the parameters provided in the design manual are empirical values that have been validated for a long time. If no special reason, it is not recommended to modify it.
Oct 23, 2018
01:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 23, 2018
01:53 AM
Hello,
Thanks a lot.
Best regards,