cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Hello, bouht a 059-Kit to break off the Kit-Prog.

   

But on the Pin VTarget comes 5V out.

   

My project runs on 1.8V or 3.3V, but not on 5V.

It´s a solution to use this Kitprog with low voltage apps?

0 Likes
7 Replies
rola_264706
Honored Contributor II

You can only use that kit prog interface on a 5 volt board if you want to program at lower voltages you need to use MiniProg3.

0 Likes
rola_264706
Honored Contributor II

Here is more information.

   

0 Likes
Anonymous
Not applicable

Ok, so I will buy such one.

 

0 Likes
odissey1
Honored Contributor II
0 Likes
odissey1
Honored Contributor II
        This BLE mouse kit comes with Miniprog for $49: http://www.cypress.com/documentation/development-kitsboards/cy5682-proc-ble-touch-mouse-reference-de... You still have to buy and solder 10-pin JTAG connector, which is rare and expensive (~$4/pc).   
0 Likes
JoMe_264151
Expert II

You may use the 5 pin solder post connector which is cheaper.

   

 

   

Bob

0 Likes
Anonymous
Not applicable
        Thanks for the hints. I don't need a connector. because, I use needle bed adapter to connect my PCBs, so I solder the programmer directly to the needle bed.   
0 Likes