Anonymous
Not applicable
Jul 26, 2016
11:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 26, 2016
11:13 AM
Hello, bouht a 059-Kit to break off the Kit-Prog.
But on the Pin VTarget comes 5V out.
My project runs on 1.8V or 3.3V, but not on 5V.
It´s a solution to use this Kitprog with low voltage apps?
7 Replies
Jul 26, 2016
08:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 26, 2016
08:21 PM
You can only use that kit prog interface on a 5 volt board if you want to program at lower voltages you need to use MiniProg3.
Attachments are accessible only for community members.
Jul 27, 2016
07:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2016
07:32 AM
Anonymous
Not applicable
Jul 27, 2016
07:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2016
07:52 AM
Ok, so I will buy such one.
Jul 27, 2016
05:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2016
05:27 PM
Jul 27, 2016
05:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2016
05:36 PM
This BLE mouse kit comes with Miniprog for $49: http://www.cypress.com/documentation/development-kitsboards/cy5682-proc-ble-touch-mouse-reference-de... You still have to buy and solder 10-pin JTAG connector, which is rare and expensive (~$4/pc).
Jul 27, 2016
10:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 27, 2016
10:58 PM
You may use the 5 pin solder post connector which is cheaper.
Bob
Anonymous
Not applicable
Jul 28, 2016
01:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 28, 2016
01:25 AM
Thanks for the hints. I don't need a connector. because, I use needle bed adapter to connect my PCBs, so I solder the programmer directly to the needle bed.