cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

I am trying to route SPI pins (2.2, 2.1, 2.0) to pins (2.7, 2.6, 2.5) through SmartIO.

After routing pins, I am getting signals both at (2.7, 2.6, 2.5) and (2.2, 2.1, 2.0). I want signals output only at (2.7, 2.6, 2.5) and I want to use 2.2,2.1,2.0 for other purposes. Is it possible in Cypress PSOC4-041XX kit?

I am using the configuration as shown below. I am getting spi clk both at 2.7 as well as 2.2, why is that so?

0 Likes
Reply
1 Reply
Honored Contributor II

Please post your code So we can check it . By  clicking on file and then create workspace_bundle and select minimal.

0 Likes
Reply