- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I was doint a project that requires the BLE to move into active mode when the switch is high( default status). When it goes low the device must go active and do the nevcessary things and again go back to deep sleep mode. I have trued many htings out but it doesnt seem to come out of deep sleep mode . It is always in that mode . I have tried using the SW2 interrupt pin but di dnot work. Can someone throw some light into this issue.? I would be very great ful if you could send a code over .
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
These might help -
http://www.cypress.com/?rID=95069 AN90799 - PSoC® 4 Interrupts
http://www.cypress.com/?rID=93401 AN86439 - PSoC® 4 - Using GPIO Pins
http://www.cypress.com/?rID=78797 AN86233 - PSoC® 4 Low-Power Modes and Power Reduction Techniques
http://www.cypress.com/?rID=96072 AN90114 - PSoC® 4000 Family Low-Power System Design Techniques
http://www.cypress.com/?rID=110007 AN92584 - Designing for Low Power and Estimating Battery Life for BLE Applications
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
attach your project.We will go through your project
Regards,
Vikas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
AN86233 has projects to wakeup using GPIO.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am having the same problem. Are you using the bootloader by any chance? I am about to post a new subject on this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please make sure that you are clearing the Pin Interrupt using Pin_ClearInterrupt() in the associated Pin ISR.