- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using PSoC4 BLE CYBBLE-214009 . I want to use SWD and SCK pins 0.6,0.7 as Input / output once programming is done. If I assign those pins as I/O I get this error.
Pin Error: (P0[6] has been reserved for debugging in the DWR System settings.).
Pin Error: (P0[7] has been reserved for debugging in the DWR System settings.).
I am aware that these pns are there for programming. Is there a way I can use them as GPIO, once programming is finished.
Thanks.
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum!
In system view set the "Debug Select" to: GPIO. Programming will still work, but the debugging of the project is stopped.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum!
In system view set the "Debug Select" to: GPIO. Programming will still work, but the debugging of the project is stopped.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Bob. This worked for me.