- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As per the CY8CKIT-048 product page, latest PSOC could not be used to develop firmware for this kit to evaluate PSOC Analog Coprocessor. If that is the case, how the firmware development for PSOC Analog Coprocessor can be done using hardware development kit? I would like to evaluate PSOC Analog Coprocessor as a front end for STM32 based device.
Solved! Go to Solution.
- Labels:
-
PSoC general
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Since the kit is not supported in PSoC Creator 4.2 or later revision as stated in the kit's page below.
I think that you need to download earlier revision such as PSoC Creator 4.1 or PSoC Creator 4.1 Update 1 from the following URL.
https://www.cypress.com/documentation/software-and-drivers/psoc-creator-software-archive
Although I have not tried that kit, I hope that the kit should be supported in PSoC Creator 4.1 Update1.
moto
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Since the kit is not supported in PSoC Creator 4.2 or later revision as stated in the kit's page below.
I think that you need to download earlier revision such as PSoC Creator 4.1 or PSoC Creator 4.1 Update 1 from the following URL.
https://www.cypress.com/documentation/software-and-drivers/psoc-creator-software-archive
Although I have not tried that kit, I hope that the kit should be supported in PSoC Creator 4.1 Update1.
moto