cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Hi,

   

    We are a module manufacturer for Cypress PRoC modules.  We need a way to measure packet error rate during production tests.  We are using standard HCI commands such as  LE_Transmitter_Test, LE_Receiver_Test and LE_Test_End,  but they do not provide any RSSI nor packet error count information.  Is there any other HCI commands (mostly vendor specific in other platforms) in Cypress PRoC solutions that will provide those receive statistic data ?

   

Please help.

0 Likes
1 Solution
AnjanaM_61
Moderator
Moderator

Hi,

   

Attached Cypress MTK test firmware. Please go through he documentation for details.

   

Hope this will be helpful for you.

   

Thanks,

   

Anjana

View solution in original post

0 Likes
5 Replies
Anonymous
Not applicable

You could try opening a case with cypress support to get direct feedback on your question/case;

   

Otherwise, check out this similar thread post: http://www.cypress.com/forum/psoc-4-ble/ble-certification-receiver-blocking-setup

0 Likes
AnjanaM_61
Moderator
Moderator

Hi,

   

Attached Cypress MTK test firmware. Please go through he documentation for details.

   

Hope this will be helpful for you.

   

Thanks,

   

Anjana

View solution in original post

0 Likes
Anonymous
Not applicable

Thanks Anjana.   I have gone through similar sets of documentations long before, and knowing that Cypress is taking a proprietary commands approach for manufacturing support.   Since we have developed our own general BLE stack to drive different BLE platforms using standard HCI commands (as well as a few other vendor specific HCI commands), we have been expecting Cypress would have similar vendor specific HCI commands for its PRoC/PSoC platform.   Unfortunately, this is not the case.  Anyway, thanks for your support.  I'll see if I have some other ways to deal with it.

0 Likes
CHMU_3007856
New Contributor

Hi Anjana,

I'm Mun Ei from Malaysia

Currently I'm doing the Bluetooth RF test under EN300328 for receiver blocking

May I know how to used HCI tools/

AnCo_2736831
Contributor

Yeah, I'm doing a similar project. This information would be helpful. Thanks.

0 Likes