Good Afternoon Everyone,
So I have been working on this code for a few weeks. I have downloaded a few examples in other languages and translated as best as Google could and Im still having difficulty getting this to work. I will post the project files below but first some info on where im gathering all my info from.
another student who tried this on the forums a few months back. Bob Marlowe seemed to help him a lot however the student never responded if he finished it or not
Im using his most recent code and trying to redo it. Using his transmitter code on my Scope im getting a signal out and when i flip my switch the signal changes to reflect that. So i think I have the transmission working as intended. Again im not sure as i have no serial monitor nor does the receiver work to get an LED to flash yet.
Im not expecting anyone to look at this and fix everything at once im hoping for someone to point out what I should do next or some glaring error like you forgot to do SPI_Enable();
all i want to do is send a 1 or 0 over radio. I am building a home security system for a project in my Engineering class. Thanks to anyone who can help.
So I translated your code from Russian to English. (Not that it needed to be I just translated your comments), After compiling both i get the Tx led to stop flashing so the way I understand your code means the packets are being sent. I will continue to work off your code to see if i can get the desired output. Thank you so much for this first step in the right direction.
@bobgoar. I attempted to use the SPI tutorial however it did not work after i put about an hour into it, I believe the issue is with the NRF you need to write to their registry to put them in Tx or Rx mode.
I will update this later today as I get the code to work or get stuck. Again thank you to everyone.