EZclick support with Miniprog4

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
masu_1341616
Level 5
Level 5
Distributor - TED (Japan)
10 solutions authored 10 likes received 25 sign-ins

Hello

I understood previous SLED  "About CY8CMBR3108-LQXI device support with Miniprog4"

When I tried to connect EZclick and miniprog to setup MBR3 Device.  It can not connect to Miniprog4.

It can not see Miniprog4 port on "Select I2C Target" window.

But It can connect to Miniprog3. 

Do you have any advice(Miniprog4 setting .... ) ?    

0 Likes
1 Solution
BragadeeshV
Moderator
Moderator
Moderator
First question asked 1000 replies posted 750 replies posted

Hi user_245806886​,

I can see that EZ-Click doesn't populate miniprog4 device. I have requested our software team to look into this issue.

For now,  as a workaround , you can use the Bridge control panel to load the .iic file generated using EZ-Click to the eval board.

Let us know if you face any difficulties with that.

Regards,

Bragadeesh

Regards,
Bragadeesh

View solution in original post

0 Likes
1 Reply
BragadeeshV
Moderator
Moderator
Moderator
First question asked 1000 replies posted 750 replies posted

Hi user_245806886​,

I can see that EZ-Click doesn't populate miniprog4 device. I have requested our software team to look into this issue.

For now,  as a workaround , you can use the Bridge control panel to load the .iic file generated using EZ-Click to the eval board.

Let us know if you face any difficulties with that.

Regards,

Bragadeesh

Regards,
Bragadeesh
0 Likes