cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

RyCo_4594291
New Contributor II

I am unable to communicate to CY8KIT-148 using the MagSense tuner.  I am using example code CE222867 MagSense with Feedback LEDs and have the EZI2C component in my project.  However, when I attempt to communicate to the device using MagSense, I can only select UART and not EZI2C.  How can I fix this?

0 Likes
1 Solution
RyCo_4594291
New Contributor II

I was able to fix this by updating the firmware to kitprog3 by following this thread and downloading the Firmware-loader tool

View solution in original post

0 Likes
3 Replies
LinglingG_46
Moderator
Moderator

Hi Ryan,

Download the CE222867 to KIT-148, then open the BCP(bridge control panel) tool. Could you list the slave address?

The I2C Bridge in Kit-148 is hardware connected.

pastedImage_0.png

0 Likes
RyCo_4594291
New Contributor II

Hello,

I have successfully programmed CE222867 and I can see the buttons and proximity sensor working as expected.  However, when I open the Bridge Control Panel, I do not see KitProg2 listed under the connected ports.  I am only able to communicate over UART and not EZI2C, which prevents me from using the MagSensAnnotation 2019-11-26 073841.pngAnnotation 2019-11-26 2.pnge tuner

0 Likes
RyCo_4594291
New Contributor II

I was able to fix this by updating the firmware to kitprog3 by following this thread and downloading the Firmware-loader tool

View solution in original post

0 Likes