Using the CYBLE-214009-00 Module & PSoC Creator 3.3 CP3.
I added a SPI Master V2.5 object and and plan to communicate to an F-RAM memory chip and an OLED display.
I am also using a SAR ADC and 7 analog inputs to measure voltage, temperature, etc.
Also have a BLE and CapSense objects too.
I am able to compile the project. My question deals with the pin selections made by the PSoC Creator. I am getting ready to send the pcb design off to get some prototype board made and want to double check the PSoC BLE Module pin connections. I am looking at the CYBLE-214009-00 Datasheet turned to Table 4 (page 9 of 42) I will use SWD programming (Pins P0.6 & P0.7 are dedicated to programming the BLE module) so that tells me I have to use SCB1 for SPI communications.
1. Auto pin selector placed SLCK on P0.5, which Table 4 says is for SCB0/MISO.
2. Auto pin selector placed MISO on P1.3, which Table 4 says is for SCB1/SS3.
3. Auto pin selector placed MOSI on P2.1, which Table 4 says is for SCB0/SS2.
I suppose my question is two fold -
A. If I use the 'second' SCB SPI block (i.e. SCB1)- do I have to use the following pins:
SLCK - not shown which pin to use in Table 4
MISO - P0.1 per Table 4
MOSI - not shown which pin to use in Table 4
If not then should I use the pins provided by the PSoC Creator auto assign pins function?
B. Can I dual purpose pins P0.6 & P0.7 for programing the Module and use SCB0 too?
Project file is attached. thanks
