- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
Have you tried to use simulated EEPROM with PSoC4? I can not find the EEPROM Component in PSoC Creator 3.2 or is there another way to create a permanent data array or write/read flash memory?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest you to upgrade to Creator 3.3 CP1. The emEEProm component can be used for the standard PSoC4 (not for BLE yet)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I already upgraded to version 3.3 but I'm using BLE, is there any other way to create permanent data?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Part of the BLE chip is the Supervisory flash which can be used to store data. Check the 100 projects for BLE, I think it was in the #46 range
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@bobgoar
The project for BLE_OTA lets the user to change flash memory but using another BLE device.
I want to save the data acquired during program execution into the flash memory, and load it again in the next restart.
@Bob Marlowe
Thank you Bob, I'm checking this project but a waning inside the main program says that this method is unstable because this changes the clock's peripherals frequency. I'll try it and told you the results, I'll appreciate if another idea you have in mind.
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Here is another program that is usable with the F- ram shield that Cypress sells for about $10.00. This program is for the PSOC 4 but could be used with the PSOC Ble if the device is changed and it is recompiled. There is also a PDF file on the process.