- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
When I run the 100 Projects in 100 days example "#16 Authentication", http://www.cypress.com/blog/100-projects-100-days/project-016-authentication I have problems bonding and reconnecting on my Nexus phone with CySmart app,
I don't get screen to enter Passkey and I see "Bonding in progress.. Please wait" after a while the device disconnects with "Authentication process timeout".
Below is the terminal output:
Bluetooth Stack ON:
Set the I/O capabilities:
Updated the I/O capabilities:DISPLAY_ONLY
Started to advertise
Device Connected
CYBLE_EVT_GAP_AUTH_REQ from Master:
Unauthenticated and data signing
Bonding:yes
eKeySize: 0x10
err: 0x0
CYBLE_EVT_GAP_PASSKEY_DISPLAY_REQUEST. Passkey is: 1454889.
Please enter the passkey on peer device.
CYBLE_EVT_GAP_AUTH_FAILED: 15
Device Disconnected
As far I understand the Passkey should be 6 digits but I see here as 7 digits(sometimes). Is this correct(attached is the uart log file)?
Also how do I use static passkey entry, I did see a post regarding this but could not find much information. Some example workspace would be greatly helpful.
Any inputs would be of great help and appreciate the same.
Regards
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Printf("CYBLE_EVT_GAP_PASSKEY_DISPLAY_REQUEST. Passkey is: %ld.\r\n",*(uint32*)eventParam) should work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Below code is used to display the passkey in example project
printf("CYBLE_EVT_GAP_PASSKEY_DISPLAY_REQUEST. Passkey is: %d%d\r\n",
HI16(*(uint32 *)eventParam),
LO16(*(uint32 *)eventParam));
Using of macros to display high 16-bit and low 16-bit word seems to be incorrect. Better use " printf("CYBLE_EVT_GAP_PASSKEY_DISPLAY_REQUEST. Passkey is: %ld\r\n", *(uint32 *)eventParam);" instead.
This is also discussed in thread http://www.cypress.com/forum/proc-ble/bonding-consistency-issues.
Thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Printf("CYBLE_EVT_GAP_PASSKEY_DISPLAY_REQUEST. Passkey is: %ld.\r\n",*(uint32*)eventParam) should work.