cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

How do you correctly configure an op amp in schematic capture which will take a non-inverting signal, amplify it and then send it on to ADC?  The port I am having issues with is the output port of the amplifier, where I need to connect the external feedback resistor.

0 Likes
Reply
1 Solution
Esteemed Contributor II

You have to connect your resistor to the Pin  IsenseAmp, not to the (internal) crosspoint.

   

 

   

Bob

View solution in original post

0 Likes
Reply
2 Replies
Esteemed Contributor II

You have to connect your resistor to the Pin  IsenseAmp, not to the (internal) crosspoint.

   

 

   

Bob

View solution in original post

0 Likes
Reply
Anonymous
Not applicable

OK, that worked.   Thanks!

0 Likes
Reply