cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

ShCh_1406391
New Contributor II

Hello,

   

I have made a prototype using CYBLE 022001 - 00 and currently using MiniProg3 to burn programs on it via SWD interface. I was wondering whether I can connect the same to the baseboard so I can also step into the code and debug it.

   

Is there a way to do this?

   

 

   

Thanks,

   

Shalin

0 Likes
2 Replies
JoMe_264151
Expert II

You just need the connection to the SWD-lines to debug with miniprog3. Are you programming your modules seperately or already soldered to your baseboard?

   

 

   

Bob

0 Likes
ShCh_1406391
New Contributor II

Hello Bob,

   

Just please ignore this post, I was doing a silly mistake, everything is running fine now.

   

Thanks,

   

Shalin

0 Likes