Anonymous
Not applicable
Mar 14, 2016
03:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 14, 2016
03:43 PM
I should start of by saying it is straightforward to me how to implement the required SR in Verilog-- but I like (even prefer) the DMA access readily provided by the built in component and only am rather a bit confused about the components configuration.
Granted the component allows a bit 'width' to be specified, but both inputs and outputs consist of a single terminal, with no indication that they are (or how to create one). For example if I wanted to do a parallel shift in coming from physical pins 0-7 say, with an 8 bit serial out... How does one go about attaching the eight pins to the input ? Is this possible ? Or am I misunderstanding the design/use case of this component ?
1 Reply