- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
Newly working with cypress products, I recently discovered the PRoC BLE.
I would like to create a new component for the CYBL10563-56LQXI but I always get the message "component01 is not supported by the selected device" when I use into my schematic.
An almost empty schematic with 1 input and 1 output pin (wired together) gives the same result.
I tried both "target generic device" and "PSoC4" options.
Is their any trick to do ? Or is their any rule to put into .cystate file to get it work ? Or maybe not yet supported by PSoC creator ?
Regards
Onur
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Onur Check out these videos they should help http://www.cypress.com/video-library/PSoC/psoc-creator-tutorialcomponent-creation-creating-library-p.... There are other video's that you can watch on this subject on the same page.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just tried what you did and this seems to be an error in Creator 3.2
I will create a MyCase on this and keep you informed.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It seems as if PRoC BLEs IO-pins are not freely routable. Without creating a component an input port wired to an output port configuration does not build. Error message states that the ports are not routable.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As an example, P2.4 (input) wired to P2.5 (output) outside a component compiles well with the CYBL10563-56LQXI device selected.
Onur
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Answer from Cypress Support : Component creation is not supported for this family of product.