Newly working with cypress products, I recently discovered the PRoC BLE.
I would like to create a new component for the CYBL10563-56LQXI but I always get the message "component01 is not supported by the selected device" when I use into my schematic.
An almost empty schematic with 1 input and 1 output pin (wired together) gives the same result.
I tried both "target generic device" and "PSoC4" options.
Is their any trick to do ? Or is their any rule to put into .cystate file to get it work ? Or maybe not yet supported by PSoC creator ?
Onur Check out these videos they should help http://www.cypress.com/video-library/PSoC/psoc-creator-tutorialcomponent-creation-creating-library-p.... There are other video's that you can watch on this subject on the same page.
I just tried what you did and this seems to be an error in Creator 3.2
I will create a MyCase on this and keep you informed.
It seems as if PRoC BLEs IO-pins are not freely routable. Without creating a component an input port wired to an output port configuration does not build. Error message states that the ports are not routable.
As an example, P2.4 (input) wired to P2.5 (output) outside a component compiles well with the CYBL10563-56LQXI device selected.
Answer from Cypress Support : Component creation is not supported for this family of product.