PSoC 4 MCU

[Anonymous]

I use evolution board CY8CKIT-042 with Capsense buttons. Now I want to use new version CSD 5.0 to test on our touch system and I need tune helper included. I see that there is no tune helper for debuging in 5.0 version. I probe in version CSD 2.6 threre is all working.   But I need to tested version CSD 5.0 (freq. hop and other good things that include new version). And the simplest way is to use debuger tool tune helper with EZI2C?

[Anonymous]

Try reading some of the other threads relate to CSD tune helper: try to run tuner gui for psoc 4 pioneer kit

[RyanZhao · Accepted solution]

Hi Simon,

Tuner helper of CSD 5.0 is different with but easier than CSD 2.6.

Attached is FYI.

Thanks,

Ryan

[Anonymous]

Hi rzzh,

thanks, now is working. But I have another problem, I want to change the positions of pins, because I use my own foil. I use 10 buttons, i compile and program to chip, but in tuner i get error,...

Thanks for reply.

Simon

[PriyadeepK_01]

The I2C buffer that the CapSense component uses to interact with the Tuner GUI may be greater than 256 bytes. Can you Set the I2C slave sub-address to 16-bits in EzI2C component and sub-address size to 2-byes in Tuner Software Tools->Tuner Communication setup->Sub-address.

[Anonymous]

Yes, I set 16 bits. The problems comes when I change pins from slider to buttons and set other pinout,...

[Anonymous]

now works miraculously, without any changes,...Thanks Ryan for added project,...

Regards,

Simon