Nov 22, 2019
08:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 22, 2019
08:34 AM
I am trying to run the cap sense tuner but all the pins on my board design are used up for other things. Its there a way to interface the tuner to the pins of my MiniProg3 I am using to program the device.
Thanks
Scott
Solved! Go to Solution.
1 Solution
Dec 25, 2019
10:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 25, 2019
10:01 PM
If you want to acquire and display the capsense parameter, you must have the interface.
3 Replies
Nov 24, 2019
06:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 24, 2019
06:08 PM
Hi Scott,
What is the MPN of the device you used?
If all the pins are used, there is only way to use the BLE to send out your tuner data.
Nov 25, 2019
07:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2019
07:18 AM
The MPN is CY8C4045AZI-S413
Thanks
Scott
Dec 25, 2019
10:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 25, 2019
10:01 PM
If you want to acquire and display the capsense parameter, you must have the interface.