cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Due to an project i am using the psoc 4 ble module to enable a device the ble functionality. To program the module i am using the miniprog 3. Everytime i try to program the module with the psoc programmer i got a fail. The MINIPROG 3 is listed on the psoc programmer so i think there are no driver issues.

   

My settings are:

   
        
  • Powercycle on because there is no externel power supply
  •     
  • SWD protocol
  •     
  • Controller: CY8C4247LQI-BL483 
  •     
  • 5 pin
  •    
   

The connection between the miniprog3 (CY8CKIT-002) and the PSoC 4 BLE MODULE (CY8CKIT-142) is shown in attachment CON1.jpg.   The settings for the psoc programmer and the fail message are shown in attachment PSOCPROG.jpg.

   

I am looking forward to read your replies. Thx

0 Likes
1 Solution
Anonymous
Not applicable

I solved the problem myself. The solution ist that for some reason you can't use the PSoC programmer to program the PSoC 4 BLE MODULE. You have to program it by following these steps:

   
        
  • In PSoC Creator -> DEBUG -> PROGRAM
  •     
  • click on miniprog3 and open "Port Settings"
  •     
  • Active Protocol: SWD
  •     
  • Clock Speed 24MHz
  •     
  • Acquire Mode: Powercycle
  •     
  • Connector 5 pin 
  •     
  • Press OK and Port acquire
  •     
  • then click on found device under miniprog 3 and click connect
  •     
  • click ok and FINISHED 
  •    

View solution in original post

0 Likes
2 Replies
Anonymous
Not applicable

I solved the problem myself. The solution ist that for some reason you can't use the PSoC programmer to program the PSoC 4 BLE MODULE. You have to program it by following these steps:

   
        
  • In PSoC Creator -> DEBUG -> PROGRAM
  •     
  • click on miniprog3 and open "Port Settings"
  •     
  • Active Protocol: SWD
  •     
  • Clock Speed 24MHz
  •     
  • Acquire Mode: Powercycle
  •     
  • Connector 5 pin 
  •     
  • Press OK and Port acquire
  •     
  • then click on found device under miniprog 3 and click connect
  •     
  • click ok and FINISHED 
  •    

View solution in original post

0 Likes
JoMe_264151
Expert II

Welcome in the forum!

   

I think you should be able to use the programmer. You will have to make the same settings (power cycle is needed!). Although I would use 1.6MHz as the clock speed.

   

 

   

Bob

0 Likes