- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can not seem to get a board of mine with an 8 pin PSoC4 device (CY8C4013SXI-400T) to program using a MiniProg3. I set up Creator with the following set up, it does see the MiniProg3 but fails to acquire the device.
Thanks
Scott
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ekta,
I found my issue … I had a part pined out worn which was causing my issues.
Scott
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Scott,
Can you send the screenshot of the error you are getting. You can try programming the device using PSoC Programmer.
Please have a look at the Programming and debugging section (page 10) of the Hardware Design Consideration application note: https://www.cypress.com/file/141176/download.
Regards,
Ekta
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ekta,
I found my issue … I had a part pined out worn which was causing my issues.
Scott