- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am using CYBL11573-56LQXI module and detecting a ZCD on P2.4 and executing an Interrupt Handler for a rising edge. And it works perfectly.
When I transferred the same code to CYBLE-022001-EVAL EZ-BLE™ Board and assigned a pin for same function as above even if the pulse is reaching, I am not getting output (which probably means the Interrupt Handler is not getting executed). And I tried it on 3 different pins (P0.4, P0.5, P1.7) on the module.
What could be the reason.
Thank You,
Ameya.
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ameya_mahajan_2724956 ,
Did you try with a different CYBLE-022001-EVAL EZ-BLE™ board ?
Please share your project so that we can verify the same for CYBLE-022001-EVAL EZ-BLE™ board .
-Gyan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ameya_mahajan_2724956 ,
Did you try with a different CYBLE-022001-EVAL EZ-BLE™ board ?
Please share your project so that we can verify the same for CYBLE-022001-EVAL EZ-BLE™ board .
-Gyan