- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
for EMC test I need to put the BLE radio of the BYBLE-022001 in a particular test mode, i.e. contiguous transmit on a low/mid/high frequency channel at low/mid/high power and in contiguous receive mode. My PCB allows access to the serial interface via FTDI USB-UART. Is there any example program which allows me to switch between such modes, e.g. HCI or AT commands etc.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please find the firmware attached with the below KBA for the RF certification.
Test Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please find the firmware attached with the below KBA for the RF certification.
Test Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073
Thanks,
P Yugandhar.