cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC 4 MCU

Anonymous
Not applicable

Hi everyone, i'm new in cypress devices. I have a CYBLE-022001-00 and i need to connect this module to my Xilinx Zynq-7000 Board as a receiver for some data (using UART pins only).

I build, program and debug my system in Vivado Design Suite for Xilinx devices. So can I use a CYBLE-022001-00 module in my project? How I need to program and debug it? What a features and procedures?

Thanks

0 Likes
Reply
1 Solution
Anonymous
Not applicable

Hello Andrey,

   

Based on these requirements, you should look at the recently released EZ-Serial firmware platform for Cypress EZ-BLE modules:

   

http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform

   

This page describes the capabilities of the platform and links to a detailed User Guide with lots of reference material and examples.

View solution in original post

0 Likes
Reply
1 Reply
Anonymous
Not applicable

Hello Andrey,

   

Based on these requirements, you should look at the recently released EZ-Serial firmware platform for Cypress EZ-BLE modules:

   

http://www.cypress.com/documentation/software-and-drivers/ez-serial-ez-ble-module-firmware-platform

   

This page describes the capabilities of the platform and links to a detailed User Guide with lots of reference material and examples.

View solution in original post

0 Likes
Reply