- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a custom board with CYBLE-012011 module. I am trying to flash the same using kitprog on PSOC 4 BLE pioneer kit. But the kitprog is not able to recognise the target. It says "Unknown Target". I tried updating firmware of kitprog, still no luck. Please help. What could be the show stopper? PFA schematic and images of PCB.
Solved! Go to Solution.
- Tags:
- ble
- cyble012011
- ez-ble creator module
- ez-ble module
- ez-ble proc module
- kitprog
- kitprog2
- pioneer kit
- psoc 4 ble
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Programming with kitprog requires the Reset pin.
Is the Reset pin connected?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are two kinds of KitProg.
It is KitProg and KitProg2.
These are different things, which are you using?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using the CY*CKIT-042-BLE Pioneer baseboard to flash my custom PCB.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using CY8CKIT-042-BLE pioneer kit to flash my board. I'm using jumper wires to connect the SWD pins to my board.
---
Regards,
T N RAJ VIGNESH,
SALIEABS Electronics Engineers LLP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Programming with kitprog requires the Reset pin.
Is the Reset pin connected?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No. It is not. But on the same board I soldered CYBLE-212019 module and it got programmed. Anyways I'll give a try by connecting the reset pin also.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks you were correct. One board just flashed without the reset pin connected and the other dint. I connected the reset pin to kitprog, still it dint work. I removed the pull up resistor connected to the reset pin and it then worked.